F 350 4WD Super Duty V10-6.8L (2002)
Hydraulic Hose: Service and Repair
Clutch Hydraulic Fluid Tubes-Clutch Master Cylinder-to-Slave Cylinder
Removal
CAUTION: Remove the entire clutch hydraulic system from the vehicle as an assembly when installing a new clutch master cylinder-to-slave
cylinder hydraulic tube.
1. Disconnect the clutch hydraulic tube from the dash clip.
2. Raise and support the vehicle.
3. Unlock and remove the slave cylinder from the transmission.
-
Compress and twist the slave cylinder to unlock it from the transmission.
4. Disconnect the clutch hydraulic tube from the floor pan clip. Position the slave cylinder and hydraulic tube forward below the left engine bank.
This will make it easier to unlock the clutch master cylinder from the clutch pedal and support bracket by reducing tension on the hydraulic tube.
5. Lower the vehicle.
6. WARNING: The clutch pedal is under spring tension.
Unlock the push rod bushing retaining clips and separate the clutch master cylinder push rod from the clutch pedal.
7. Remove and discard the push rod bushing.