F 350 4WD Super Duty V10-6.8L VIN S (2004)
14. NOTE: Always use the same new inner pinion bearing installed when taking the measurement for drive pinion position shim selection.
Using the special tool, an axle bearing/seal plate, and a suitable press, install the pinion bearing.
15. NOTE: Use the thickness of the old drive pinion bearing preload shims as a starting point for setting pinion bearing preload.
Inspect the drive pinion bearing preload shims for damage. Discard them if necessary. New shims are available in the thickness shown in the
following chart.
Available Drive Pinion Bearing Preload Shims
16. Assemble the drive pinion bearing preload shims onto the pinion and install the pinion into the differential housing.
17. Install the outer pinion bearing.
18. Using the special tool, install the pinion flange.
