F 350 4WD Super Duty V10-6.8L VIN S (2004)
Installation
1. CAUTION: Do not tighten the bolt that attaches the transfer case control lever assembly to the transmission case at this time.
Align the new transfer case control lever assembly pivot bolt over the correct mounting hole in the transmission case and start the bolt into the
threaded hole by hand.
1
For vehicles with a gasoline engine and manual transmission, or a diesel engine and manual or automatic transmission, install the new bolt in
the forward (LH) threaded hole in the transmission case.
2
For vehicles with a gasoline engine and automatic transmission, install the new bolt in the rearward (RH) threaded hole in the transmission
case.
2. Position the second bolt in the unused threaded hole in the transmission case.
^
For vehicles with a gasoline engine and manual transmission, or a diesel engine and manual or automatic transmission, position the pin in the
rearward (RH) threaded hole in the transmission case.
^
For vehicles with a gasoline engine and automatic transmission, position the pin in the forward (LH) threaded hole in the transmission case.
3. CAUTION: Verify that the control rod is still attached correctly to the transfer case.
CAUTION: Verify that the transfer case is still in 4H.
Connect the control rod to the lower shifter arm.
4. CAUTION: Make sure the transfer case is in 4H. Hold the control lever against the 4H detent while tightening the bolt. This will ensure correct
transfer case gear engagement during transfer case operation.
Hold the control lever against the 4H detent while tightening the bolt.
5. Lower the vehicle.