F 350 4WD Super Duty V10-6.8L VIN V (2005)
Camshaft Position Sensor: Service and Repair
CAMSHAFT POSITION (CMP) SENSOR
Removal and Installation
1. Disconnect the battery ground cable.
2. Disconnect the CMP sensor electrical connector.
3. Remove the bolt and the CMP sensor. Discard the O-ring seal.
-
To install, tighten to 10 Nm (89 lb-in).
-
Lubricate the O-ring seal with clean engine oil prior to installation.
4. To install, reverse the removal procedure.
