F 350 4WD Super Duty V10-6.8L VIN V (2005)
Pressure Regulating Solenoid: Service and Repair
Line Pressure Control Solenoid PC-A
Line Pressure Control Solenoid - PC-A
Material
Removal
NOTE: The pressure switches shown in this procedure will not be applicable to all vehicle applications. Some vehicles will not have the pressure
switches or the harness installed in the valve body.
1. With the vehicle in NEUTRAL.
2. Remove the transmission main control valve body. For additional information, refer to Solenoid Body.
3. Remove the solenoid body electrical connector O-ring seal.
4. Partially remove the solenoid body electrical wire harness.
1. Remove the wire harness to solenoid body bolts.
2. Disconnect the electrical connector from the pressure control solenoid (PC-A) and the shift solenoid (SSPC-C)
3. Lift the tab on the bulkhead connector, twist and push the bulkhead connector through the solenoid body.
