F 350 4WD Super Duty V10-6.8L VIN Y (2006)
Brake Pad: Service and Repair
Rear
Brake Pads
Material
Removal and Installation
1. If necessary, remove the brake fluid until the brake master cylinder reservoir is half full.
2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
3. CAUTION: Do not pry in caliper sight hole to retract pistons as this can damage the pistons and boots.
CAUTION: Do not allow the brake caliper to hang from the brake hose or damage to the hose can occur.
Remove the 2 brake caliper bolts and position the caliper aside.
^
Support the caliper using mechanic's wire.
^
To install (F-250, F-350 single rear wheel caliper), tighten to 35 Nm (26 ft. lbs.).
^
To install (F-350 dual rear wheel caliper), tighten to 76 Nm (56 ft. lbs.).
^
To install (F-450, F-550 dual rear wheel caliper), tighten to 62 Nm (46 ft. lbs.).
