F 350 4WD Super Duty V10-6.8L VIN Y (2006)
3. CAUTION: Do not remove the timing chain wedge tool at any time during assembly. If the special tool is removed or out of placement, the
engine front cover must be removed and the engine must be retimed.
CAUTION: The timing chain must be installed in its original position onto the camshaft sprocket using the scribed marks, or damage to valves
and pistons will result.
Verify the camshaft sprocket and timing chain scribe marks are still in alignment.
4. CAUTION: Do not allow the roller followers to move out of position when installing the camshaft.
Install the camshaft bearing caps in their original locations.
^
Lubricate the camshaft bearing caps with clean engine oil.
^
Position the front camshaft bearing cap.
^
Position the remaining camshaft bearing caps.
^
Install the bolts loosely.
5. Tighten the RH camshaft bearing cap bolts in 2 stages:
^
Stage 1: Tighten to 8 Nm (71 inch lbs.) in the sequence shown.
^
Stage 2: Tighten an additional 45 degrees.
