F 350 4WD Super Duty V10-6.8L VIN Y (2006)
10. Remove the nut and the starter wiring harness support bracket.
11. Remove the nut and position the transmission oil cooler lines and bracket aside.
12. CAUTION: Damage to the turbine shaft speed (TSS)/output shaft speed (OSS) sensors may occur and cause the transmission or torque converter
operational concerns if the transmission is raised prior to removing TSS/OSS.
CAUTION: Sensor bosses must be cleaned prior to removal and then plugged to prevent contamination from damaging internal components.
If the vehicle is equipped with TSS and OSS sensors, remove the sensors and install plugs in the transmission.
13. Using the special tools, raise the engine.
14. CAUTION: Support the transmission on the oil pan rails only or internal transmission damage can occur.
Install a suitable transmission jack and raise the transmission.
