F 350 4WD Super Duty V10-6.8L VIN Y (2006)
14. NOTE: LH shown, RH similar.
Connect the radio ignition interference capacitor electrical connectors.
15. Install the accessory drive belt tensioner and the 3 bolts.
^
Tighten to 25 Nm (18 ft. lbs.).
16. Install the coolant pump pulley and the 4 bolts.
^
Tighten to 25 Nm (18 ft. lbs.).
17. Install the accessory drive idler pulley and the 3 bolts.
^
Tighten to 25 Nm (18 ft. lbs.).
18. Lubricate the engine front cover and the crankshaft seal inner lip with clean engine oil.
19. Using the special tools, install a new crankshaft seal into the engine front cover.
20. NOTE: If not secured within 4 minutes, the sealant must be removed and the sealing area cleaned. To clean the sealing area, use silicone gasket
