F 350 4WD Super Duty V10-6.8L VIN Y (2006)
^
To install, tighten to 27 Nm (20 ft. lbs.).
3. Disconnect the pressure line from the retaining clip.
4. NOTE: Thoroughly clean all foreign material from the threads.
Disconnect the pressure line-to-steering gear fitting and remove the pressure line.
^
Discard the Teflon(R) seal.
^
To install, tighten to 35 Nm (26 ft. lbs.).
5. To install, reverse the removal procedure.
^
Using the special tool, install 2 new Teflon(R) seals on the pressure line fittings.
^
Fill the power steering system.
