F 350 4WD Super Duty V10-6.8L VIN Y (2006)
Throttle Body: Service and Repair
Throttle Body
THROTTLE BODY
Removal
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related components. Highly
flammable mixtures are always present and can be ignited. Failure to follow these instructions may result in personal injury.
1. Disconnect the battery ground cable.
2. Remove the air cleaner outlet tube.
3. Disconnect the electronic throttle control electrical connector.
4. Disconnect the throttle position (TP) sensor electrical connector.
5. Remove the 4 throttle body (TB) bolts and the throttle body and discard the TB gasket.
Installation
1. Position a new TB gasket, the TB and tighten the 4 bolts in 2 stages:
-
Stage 1: Tighten to 9 Nm (80 lb-in).
-
Stage 2: Tighten an additional 90 degrees.
2. Connect the TP sensor electrical connector.
3. Connect the electronic throttle control electrical connector.
4. Install the air cleaner outlet tube.
5. Connect the battery ground cable.
