F 350 4WD Super Duty V10-6.8L VIN Y (2006)
NOTE:
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
All vehicles
1. Depower the system.
2. Remove the driver air bag module.
3. NOTE: Make sure the wheels are in the straight-ahead position.
Remove the steering wheel.
4. Apply 2 strips of masking tape across the clockspring to prevent accidental rotation.
5. Twist the tilt wheel handle and shank and remove.
6. Remove the steering column opening lower finish panel.
7. Remove the 3 screws and the lower steering column shroud.
8. Remove the ignition switch lock cylinder.
1
Position the lock cylinder to RUN.
2
Using a suitable tool, push upward on the cylinder release tab while pulling the cylinder outward.
9. Remove the upper steering column shroud.
Vehicles with a passive anti-theft system
