F 350 4WD Super Duty V10-6.8L VIN Y (2006)
2. Disconnect the safety belt warning switch electrical connector.
-
Remove the pin-type retainer from the safety belt warning switch electrical connector.
3. Remove the front inboard track-to-seat pan bolt.
4. Loosen the rear inboard track-to-seat pan bolt to allow the removal of the electrical connector.
5. Position the electrical connector as shown and remove it through the seat opening.
All seats
6. Remove the nut and the safety belt buckle.
-
To install, tighten to 40 Nm (30 lb-ft).
7. To install, reverse the removal procedure.
8. Check the active restraint system for correct operation.
