F 350 4WD Super Duty V10-6.8L VIN Y (2006)
3. NOTE:
-
Note the safety belt buckle switch wire harness routing for installation.
-
Note position of locator tab for installation.
Remove the nut and the safety belt buckle.
-
To install, tighten to 40 Nm (30 lb-ft).
4. To install, reverse the removal procedure.
5. Install the seat on the side with the affected safety belt buckle.
6. Check the active restraint system for correct operation.
Safety Belt Buckle - Rear, SuperCab
SAFETY BELT BUCKLE - REAR, SUPERCAB
Removal and Installation
WARNING: All safety belt assemblies (including retractors, belt tension sensor (BTS), if equipped, buckles, shoulder belt height adjusters [if
equipped], child safety seat tether attachments and attaching hardware) should be inspected after every collision. All new belt assemblies
should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a
collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these
instructions could increase the risk of injury in collisions.
NOTE: Safety belt buckles shown, safety belt and buckle similar.
1. From the bottom of the seat backrest, push the seat backrest upward, then pull the bottom outward and remove from the vehicle.
2. Remove the bolt and the safety belt buckles.
-
To install, tighten to 55 Nm (41 lb-ft).
