F 350 4WD Super Duty V10-6.8L VIN Y (2006)
4. Remove the bolt and the safety belt retractor anchor.
-
To install, tighten to 40 Nm (30 lb-ft).
5. Remove the rear scuff plate and the rear corner trim panel.
6. Remove the bolt and the safety belt retractor.
-
To install, tighten to 40 Nm (30 lb-ft).
7. NOTE: Make sure the safety belt webbing is not twisted prior to installation.
To install, reverse the removal procedure.
8. Check the active restraint system for correct operation.
