F 350 4WD Super Duty V10-6.8L VIN Y (2006)
Clutch Pedal Assembly: Service and Repair
Clutch Pedal
Removal and Installation
1. Disconnect the clutch hydraulic tube from the dash clip.
2. With the vehicle in NEUTRAL, position it on a hoist.
3. NOTE: The 5.4L and 6.8L clutch control system has a heat shield that covers most of the tube and clutch slave cylinder. To unlock, the slave
cylinder, slide the heat shield back and off the slave cylinder. Slide the heat shield over the tube.
Unlock and remove the slave cylinder from the transmission.
^
Compress and twist the clutch slave cylinder counterclockwise to unlock it from the transmission.
4. Disconnect the clutch hydraulic tube from the floor pan clip. Position the clutch slave cylinder and hydraulic tube forward below the left engine
bank. This will make it easier to unlock the clutch master cylinder from the clutch pedal and support bracket by reducing tension on the hydraulic
tube.
5. Lower the vehicle.
6. WARNING: The clutch pedal is under spring tension.
Unlock the push rod bushing retaining clips and separate the clutch master cylinder push rod from the clutch pedal.
7. Remove and discard the push rod bushing.
