F 350 4WD Super Duty V10-6.8L VIN Y (2006)
5. NOTICE: Do not continue to tighten the C-Frame and Screw Installer/Remover if the U-joint bottoms out in the yoke or damage will
occur to the center bearing shield.
Using the C-Frame and Screw Installer/Remover, press the 2 bearing cups out of the opposite side of the driveshaft center yoke.
-
Alternate the pressure between the U-joints.
6. Slide the U-joint spider toward the screw side of the C-Frame and Screw Installer/Remover. Insert a suitable half moon punch on the exposed
spider leg.
7. Using the C-Frame and Screw Installer/Remover, press the 2 remaining bearing cups out of the opposite side of the driveshaft center yoke.
8. Remove the bearing cups with gripping pliers.
9. Remove remaining bearing cups and spiders, and on the one-piece rear driveshaft, remove the spring.
-
The centering ball on the driveshaft end yoke is not repairable. Discard the driveshaft if the centering ball is damaged.
Assembly
1. Position the spider in the driveshaft end yoke, and position the bearing cup on the spider trunion.
2. Using the C-Frame and Screw Installer/Remover, press the bearing cup far enough into the driveshaft end yoke to place the opposite bearing cup
on the spider trunion.