F 350 4WD Super Duty V10-6.8L VIN Z Bi-Fuel (2001)
15. Remove the bolts.
16. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools
cause scratches and gouges which make leak paths. Use a plastic scraping tool to remove all traces of old sealant.
Remove the engine front cover from the front cover to cylinder block dowel.
^
Remove the engine front cover gasket and clean and inspect the mating surfaces.
Installation
1. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools
cause scratches and gouges which make leak paths. Use a plastic scraping tool to remove all traces of old sealant.
NOTE:
^
If the engine front cover is not secured within four minutes, the sealant must be removed and the sealing area cleaned with metal surface
cleaner. Allow to dry until there is no sign of wetness, or four minutes, whichever is longer. Failure to follow this procedure can cause future
oil leakage.
^
Make sure that the engine front cover gasket is in place on the engine front cover before installation.
