F 350 4WD Super Duty V10-6.8L VIN Z Bi-Fuel (2001)
Vehicles with 4R100 transmission
5. CAUTION: Install a new inline transmission fluid filter (XC3Z-7Bl55-BA) every 48,000 kin (30,000 miles) and always as part of a transmission
overhaul or exchange. If the vehicle was not equipped with an inline fluid filter install a new inline transmission fluid filter kit (XC3Z-7Bl55-AA)
according to the instructions supplied with the kit as pail of a transmission overhaul or exchange.
NOTE: The inline transmission fluid filter, if so equipped, is attached to the fluid cooler return tube. The fluid cooler return tube runs from the
Oil-To-Air (OTA) transmission fluid cooler to the rear transmission cooler tube case fitting.
Remove, and discard the inline transmission fluid filter, if so equipped.
6. If not done previously, carry out the transmission fluid cooler flow test procedure.
All vehicles
7. CAUTION: Do not attempt to backflush and clean the OTA transmission fluid cooler. Install a new OTA transmission fluid cooler as part of a
transmission overhaul or exchange. Failure to follow these directions may result in transmission damage.
Remove the OTA transmission fluid cooler.
1
Disconnect the fluid cooler tubes from the fluid cooler.
2
Remove the bolts and the fluid cooler.
Installation
All vehicles
1. CAUTION: Do not attempt to backflush and clean the OTA transmission fluid cooler. Install a new OTA transmission fluid cooler as part of a
transmission overhaul or exchange. Failure to follow these directions may result in transmission damage.
Install the OTA transmission fluid cooler.
1
Position the fluid cooler in the vehicle.
2
Install the lower bolts.
3
Connect the fluid cooler tubes to the fluid cooler.
