F 350 4WD Super Duty V10-6.8L VIN Z CNG (2003)
7. Connect the heated seat switch electrical connector.
All seats
8. CAUTION: Bend the side shield slightly to insure the shield is not scratched by the recliner lever.
Position the side trim cover and install the three trim cover screws.
-
The seat backrest pivot bolt shaft must be inserted into the cover standoff.
9. Push the rearward lower corner of the side shield to engage the metal retaining clip.
10. Position the lumbar adjuster control and install the two mounting screws.
-
Install the adjuster knob.
11. Position the seat back recliner lever cover and install the screw.
