F 350 4WD Super Duty V10-6.8L VIN Z CNG (2003)
2. Remove the safety belt buckles.
1
Using the special tool 501-010 (T77L-2100-A), remove the bolt.
2
Remove the safety belt buckles.
INSTALLATION
1. To install, reverse the removal procedure.
^
See the removal procedure or Specifications for torque specifications.
NOTE:
^
Make sure the safety belt webbing is not twisted prior to installation.
^
Make sure to tighten bolts to specification.
2. Check the restraint system for correct operation.
Crewcab
Torx Bit Tool Set Used For T55 "Torx Plus" Bit
SPECIAL TOOL(S)
REMOVAL
NOTE: Rear bench seat shown, rear captains chair is similar.
1. Remove the utility tray, if necessary.
2. Remove the safety belt buckles.
1
Use the T-55 Torx bit to remove the LH safety belt buckle bolt.
2
Use the T-55 Torx bit to remove the RH safety belt buckle bolt.