F 350 4WD Super Duty V10-6.8L VIN Z CNG (2003)
2. Connect the seat control switch electrical connector.
3. NOTE: Bend the side shield slightly to insure the shield is not scratched by the recliner lever.
Position the side trim cover. Install the three trim cover screws.
-
The seat backrest pivot bolt shaft must be inserted into the cover standoff.
4. Push the rearward lower corner of the side shield to engage the metal retaining clip.
5. Position the lumbar adjuster control. Install the two mounting screws. Install the adjuster knob.
6. Position the seat back recliner lever cover. Install the screw.
7. WARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes and instructions in the front seat
removal and installation procedure.