F 350 4WD Super Duty V10-6.8L VIN Z CNG (2003)
17. Using the special tool, press the opposite bearing cup to just below the snap ring groove.
18. install the snap ring.
19. Position the bearing cup on the spider bunion in the centering flange yoke.
20. Using the special tool, press the bearing cup into position.
21. CAUTION: The assembly requires centering to install the final bearing cup, due to spring pressure.
NOTE: Position the jaws of the special tool into the driveshaft center yoke bearing cup bores.
With the special tools in position, hand-tighten the Differential Bearing Remover to center the spider bunion in the bore.
