F 350 4WD Super Duty V8-5.4L (2009)
3. Remove the bolt and electrical connector bracket (if equipped).
-
To install, tighten to 10 Nm (89 lb-in).
4. Release the cushion trim cover J-clips.
5. From under the outboard side of the cushion frame, remove the pin-type retainers and remove the cushion trim cover.
6. Remove the cushion frame from the cushion foam pad.
-
If equipped with power seat track, feed the seat control switch wire harness through the opening in the cushion trim cover.
7. Remove the hog rings and cushion trim cover.
Seats with heat
8. Remove the cushion heater mat from the cushion foam pad.
-
On assembly, make sure the cushion heater mat is tucked in the trench.
9. Disconnect and remove the heated seat relay.
10. Remove the 2 scrivets and heated seat relay bracket.
Seats with power seat track
11. Remove the 2 screws and cushion side shield bracket.
All seats
12. Remove the seat wire harness.
-
If equipped, remove the memory seat wire harness.
13. Remove the pin-type retainers and cushion foam pad shields.
