F 350 4WD Super Duty V8-5.4L (2009)
Oil Cooler: Service and Repair
Oil Cooler
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Drain the engine cooling system.
3. Remove and discard the oil filter.
-
To install, tighten to 16 Nm (142 lb-in).
4. Disconnect the oil cooler coolant hoses and position aside.
5. NOTICE: If metal foreign material is present in the oil cooler, mechanical concerns exist. To diagnose mechanical concerns, refer to
Engine. See: Testing and Inspection
Remove the threaded shaft and the oil cooler. Inspect the engine oil cooler.
-
To install, tighten to 58 Nm (43 lb-ft).
6. To install, reverse the removal procedure.
