F 350 4WD Super Duty V8-5.4L (2009)
4. Loosely install the bolts, then tighten the bolts in 2 stages, in the sequence shown.
-
Stage 1: Tighten to 20 Nm (177 lb-in).
-
Stage 2: Tighten an additional 60 degrees.
5. Connect the CKP sensor electrical connector.
6. Position the starter wiring harness and transmission fluid cooler tubes support brackets and install the nut.
-
Tighten to 25 Nm (18 lb-ft).
7. Position the power steering pump assembly and install the 3 bolts.
-
Tighten to 25 Nm (18 lb-ft).
8. Connect the RH CMP sensor electrical connector.
9. Connect the LH CMP sensor electrical connector.
