F 350 4WD Super Duty V8-5.4L (2009)
Yes
INSTALL the removed fuse. Go To Pinpoint Test H. See: Pinpoint Test H: The Smart Junction Box (SJB) Does Not Respond To The Scan Tool
No
If the vehicle is equipped with a CDIM, INSTALL the removed fuse. GO to U10.
If the vehicle is not equipped with a CDIM, INSTALL the removed fuse. GO to U11.
-------------------------------------------------
U10 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE CDIM DISABLED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: SJB Fuse 27 (20A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. Go To Pinpoint Test N. See: Pinpoint Test N: The Circuit Deactivation Ignition Module (CDIM) Does Not Communicate
With The Scan Tool
No
INSTALL the removed fuse. GO to U11.
-------------------------------------------------
U11 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE IC DISABLED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: SJB Fuses 26 (10A) and 36 (5A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuses. Go To Pinpoint Test C. See: Pinpoint Test C: The Instrument Cluster (IC) Does Not Respond To The Scan Tool
No
If the vehicle is equipped with an APIM and/or SDARS module, INSTALL the removed fuse. GO to U12.
If the vehicle is not equipped with an APIM and/or SDARS module, INSTALL the removed fuse. An intermittent fault is not present. Go To Pinpoint
Test V. See: Pinpoint Test V: No Medium Speed Controller Area Network (MS-CAN) Communication, All Modules Are Not Responding
-------------------------------------------------
U12 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE APIM AND/OR SDARS MODULE DISABLED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: SJB Fuse 40 (20A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
