F 350 4WD Super Duty V8-5.4L (2009)
Removal and Installation
NOTICE: Suspension fasteners are critical components because they affect performance of vital components and systems and their failure can
result in major service expense. Install new components with the same component number or an equivalent component if installation is
necessary. Do not use an installation component of lesser quality or substitute design. Torque values must be used as specified during
reassembly to make sure of correct retention of these components.
All vehicles
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove and discard the stabilizer bar link lower nuts.
-
To install, tighten the new nuts to 103 Nm (76 lb-ft).
3. Remove and discard the stabilizer bar link upper nuts and remove the stabilizer bar links.
-
To install, tighten the new nuts to 80 Nm (59 lb-ft).
F-350 Single Rear Wheel (SRW), narrow frame vehicles
4. Remove the stabilizer bar bracket nuts, U-bolts, brackets and the stabilizer bar.
-
Discard the nuts and U-bolts.
-
To install, tighten the new nuts to 40 Nm (30 lb-ft).
F-250/F-350 wide frame vehicles
5. Remove the stabilizer bar bracket bolts, brackets and the stabilizer bar.
-
Discard the bolts.
-
To install, tighten the new bolts to 48 Nm (35 lb-ft).
All vehicles
6. To install, reverse the removal procedure.
