F 350 4WD Super Duty V8-5.4L (2009)
1. NOTE: Prior to installing the manual control lever shaft seal, clean the bore opening with mineral spirits.
Using the Shift Shaft Fluid Seal Installer, install the manual control lever shaft seal.
2. Loosen the 2 bolts on the Transmission Range (TR) sensor.
3. Install the manual control lever shaft.
4. NOTE: Leave a small portion of the pin exposed.
Install the manual control lever shaft retaining pin into the case.
5. NOTE: When the manual control lever shaft retaining pin is installed correctly, 2 mm (0.08 in) of the pin will be exposed.
Install a new manual control valve detent lever retaining pin.
6. Tighten the 2 bolts to 10 Nm (89 lb-in).
