F 350 4WD Super Duty V8-5.4L (2009)
2. NOTE: Do not use a silicone sealing compound or damage to the components can occur.
NOTE: Do not wait longer than 10 minutes to tighten the bolts due to the rapid cure time of the sealant.
Install the shift housing and shift housing-to-case bolts.
-
Apply gasket maker to the sealing surfaces.
-
Tighten to 23 Nm (17 lb-ft).
3. Install the lower shift lever boot and the 2 screws.
4. Apply threadlock and sealer to the gearshift lever bolt, and install the upper gearshift lever.
-
Tighten to 35 Nm (26 lb-ft).
5. Install the shift lever boot.