F 350 4WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
All vehicles
1. NOTE: The locating tabs on the gaskets must be up and toward the center of the engine, or a leak will occur.
Install the intake manifold gaskets and front module O-ring seal.
Late build
2. Install the intake manifold and bolts and tighten in the following sequence.
1
Loosely install bolts 1-8.
2
Tighten bolts 9-16 to 11 Nm (8 ft. lbs.).
3
Tighten all bolts to 11 Nm (8 ft. lbs.) in the sequence shown.
3. Install the gasket and the EGR cooler V-clamp.
