F 350 4WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
If the wear ring remained in the engine after removing the seal, use the Crankshaft Rear Ware Ring Remover to remove and discard the crankshaft
rear seal wear ring.
All Vehicles
6. Clean and inspect the crankshaft sealing surface.
Installation
Vehicles with an original service seal
NOTICE: The crankshaft rear seal and wear ring are a one-piece design and need to be installed at an assembly. Do not separate the wear ring
from the Crankshaft rear seal or damage In the seal may occur.
NOTE: An original service seal will have a wear ring without a flange and pre-applied threadlock.
NOTE: Apply a bead of threadlock around the circumference of the secondary crankshaft flange.
NOTE: Lubricate the outer diameter of the rubber seal with a solution of dish soap and water (approximately 50/50 mix) prior to assembly. Do
not use any other type of lubricant.
1. Lubricate the outer diameter of the rubber seal with a solution of dish soap and water.
