F 350 4WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
3. Using the special tool, remove the crankshaft seal.
4. NOTE: Production engine will not have a wear sleeve.
If equipped, remove the crankshaft damper wear sleeve.
Installation
1. Thoroughly clean the crankshaft front seal mounting surface.
2. Apply Threadlock 2628 to the outer circumference of the leading edge of the crankshaft.
3. NOTE: New seal and wear sleeve must not be separated.
Using the special tool, install the oil seal and wear sleeve assembly.
4. Install the crankshaft damper.