F 350 4WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
^
Inspect injector hold down bolt hole in the cylinder head and ensure it is clean and free of any oil or debris that could impact the torque of the bolt,
resulting in an improper torque reading. Install the injector and Torque the hold down bolt to 32.5 N.m (24 lb-ft). An under torqued injector hold
down bolt will result in failure (Figure 1).
NOTE
THE 6.0L TORQUE SPECIFICATION IS DIFFERENT THAN THE TORQUE SPECIFICATION USED ON THE 7.3L INJECTORS.
^
Once the injector has been installed and torqued to specification, fill the top of the injector with clean diesel engine oil. This will aid the installation
of the high-pressure oil rail and reduce the risk of damage to the injector 0-rings.
NOTE
CATASTROPHIC ENGINE FAILURE AS A RESULT OF IMPROPER INJECTOR SERVICE IS NOT CONSIDERED A MANUFACTURES
DEFECT IN MATERIAL OR WORKMANSHIP, AND MAY NOT BE COVERED BY WARRANTY.
Parts Block
OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: INFORMATION ONLY
Disclaimer
