F 350 4WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
4. Remove the press-in-place gasket.
-
Remove the cylinder head dowels.
-
Clean and inspect the gasket.
-
Clean and inspect the sealing surface.
5. NOTE: The fuel injector sleeve is made of stainless steel. Lubrication of the fuel injector sleeve removal tap is necessary. Excessive force will be
needed to get the tap started and damage to the tap can occur without lubrication.
Insert the injector sleeve tap and injector sleeve tap pilot into the cylinder head fuel injector bore. Tighten injector sleeve tap 1-1/2 to 2 turns.
6. Install the fuel injector sleeve removal tool into the threaded sleeve. Using the special tools, remove the fuel injector sleeve from the cylinder head
fuel injector bore. Discard the sleeve.
7. Using the special tool, clean the fuel injector bore of deposits and hardened sealant.