F 350 4WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
Voltage Regulator: Service and Repair
VOLTAGE REGULATOR
REMOVAL
1. NOTE: This procedure applies to gasoline-engine generators only.
Remove the generator.
2. Remove the generator brush and terminal holder and the voltage regulator.
1
Remove the four voltage regulator screws.
2
Remove the generator brush and terminal holder and the voltage regulator.
3. Separate the generator brush and terminal holder from the voltage regulator.
1
Remove the screw cap.
2
Remove the two generator brush and terminal holder screws.
3
Separate the generator brush and terminal holder from the voltage regulator.
INSTALLATION
1. Install the brush and terminal holder on the voltage regulator.
1
Position the brush and terminal holder on the voltage regulator.
2
Install the generator brush and terminal holder screws.
3
CAUTION: Make sure screw cap is installed over Test Terminal A to prevent accidental shorting of the battery positive connection.
Install the screw cap.