F 350 4WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
11. Clean and inspect the wheel knuckle ball Joint bores.
Installation
1. Position the wheel knuckle onto the axle housing.
2. Install the nut onto the lower ball Joint. Do not tighten the nut at this time.
3. Install the insert and the castellated nut onto the upper ball Joint. Do not tighten the nut at this time.
4. Tighten the lower ball Joint retaining nut. Pre-tighten the nut to 47 Nm (35 ft. lbs.).
5. NOTE: Do not loosen the castellated nut to install the cotter pin.
Install the cotter pin into the upper ball Joint.
1
Tighten the upper ball Joint castellated nut.