F 350 4WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
3. Disconnect the digital Transmission Range (TR) sensor electrical connector.
4. Remove the digital Transmission (TR) sensor.
1
Remove the bolts.
2
Remove the digital Transmission Range (TR) sensor.
5. NOTE: A No. 53 drill bit (1/16 inch) can be used instead to remove the manual lever shaft retaining pin.
Using the special tool, remove the manual lever shaft retaining pin.
6. CAUTION: Be careful not to damage the manual control lever bore.
NOTE: The manual control lever and manual control lever shaft are one piece.
NOTE: Use a crescent wrench on the manual control lever or outer flats of manual control lever shaft assembly when removing the inner manual
