F 350 4WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
Install the new rubber-coated sealing washers and the new cooler line case fittings.
1
Install one rubber-coated sealing washer on each cooler line case fitting.
2
Install both cooler line case fittings into the CBV assembly fittings.
3
Install one rubber-coated sealing washer on each cooler line case fitting.
2. CAUTION: Damage will occur to the rubber-coated sealing washers and transmission fluid will leak if the cooler line case fitting are
over-tightened.
NOTE: Align the rubber-coated sealing washers while installing CBV assembly on the transmission case.
Install the CBV assembly.
3. Install the fluid cooler tubes in the front and rear cooler line case fittings.
4. CAUTION: Do not use any fluid approved for MERCON V application. Using a fluid rated for MERCON V may cause internal damage in
MERCON only applications.
MERCON ATF is being replaced by MERCON V ATF as a service fluid, per TSB 06-14-4..
Fill the transmission with the specified type and quantity of transmission fluid.
5. Check for leaks.
