F 350 4WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
3. Disconnect the driveshaft from the axle flange.
1
Remove and discard the bolts.
2
Remove and discard the U-joint retainers.
^
Using mechanics wire, support the driveshaft.
4. CAUTION: After removal of the pinion nut, discard it. A new nut must be used for installation.
Remove the pinion nut using the special tool.
5. NOTE: Index-mark the drive pinion flange and the pinion shaft.
Remove the pinion flange, using the special tool.
^
Remove the rear axle drive pinion seal. For additional information, refer to Drive Pinion Flange and Drive Pinion Seal.
^
Remove the rear axle drive pinion shaft oil Slinger.