F 350 4WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
6. Force up on the metal flange of the rear axle drive pinion seal. Install gripping pliers to the seal flange and strike with a hammer until the rear axle
drive pinion seal is removed.
Remove the oil Slinger and the outer pinion bearing.
7. Install the special tool and, with a soft-faced hammer, drive the pinion out of the front bearing cone and remove it through the rear of the housing.
8. NOTE: Remove the collapsible spacer and discard it.
Use the special tool to remove the pinion bearing.
9. NOTE: Do not remove the pinion bearing cups from the carrier casting unless the cups are damaged.
NOTE: Tap alternately on opposite sides of the cups to prevent them from cocking in the bore.
Use a suitable brass drift to remove the differential bearing cups.
Installation
Using 205-098
