F 350 4WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
23. NOTE: The service tools designed for a nominal pinion with 0 etch.
NOTE: Use a feeler gauge or clean, flat drive position shims as a measuring device.
NOTE: Do not attempt to force the feeler gauge or shims between the Gauge Block and the Gauge Tube. A slight drag indicates a correct
selection.
Measure between the Gauge Block and the Gauge Tube. Record the measurement. Refer to the Pinion Ring Gear Variation Number for shim
selection information.
24. CAUTION: Follow the drive pinion bearing preload shim and drive pinion position shim assembly as directed or unit failure can result.
Install the correct thickness drive pinion position shim, and the oil slinger, if so equipped, on the pinion.
25. NOTE: Always use the same new inner pinion bearing installed when taking the measurement for drive pinion position shim selection.
Using the special tools and a suitable press, install the inner pinion bearing.
26. NOTE: Use the thickness of the old drive pinion bearing preload shims as a starting point for setting pinion bearing preload.
Inspect the drive pinion bearing preload shims for damage. Discard them if necessary. New shims are available in the thickness shown in the
following chart.
Available Drive Pinion Bearing Preload Shims
27. Assemble the drive pinion preload shims onto the pinion and install the pinion into the differential housing.
