F 350 4WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
2. Using the special tool, press the bearing cup far enough into the driveshaft end yoke to place the opposite bearing cup on the spider trunion.
3. Position the opposite bearing cup on the spider trunion.
4. Using the special tool, press the bearing cup to just below the snap ring groove.
5. Install the new snap ring.
6. Using the special tool, press the opposite bearing cup to just below the snap ring groove.
7. Install the new snap ring.
8. NOTE: Align the index marks made during disassembly.
Position the driveshaft center yoke on the spider.