F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
NOTICE:
Use care not to tear the silk film bag during installation. The purpose of the silk film bag is to provide a barrier between the foam and seat back to
prevent squeaks.
4.
Carefully install the silk film bag onto the driver seat back frame.
5.
Slide the foam and seat back trim assembly over the seat back frame, making sure the trim assembly is fully seated on the frame and headrest pan.
Take care not to damage the foam when sliding the foam over the clamp. See Figure 10.
6.
Pull down the seat back trim while seating the hook-and-loop strips by hand.
7.
Connect the J-clip on the seat back.
8.
On regular cab vehicles only, install the latch handle on the back of the seat.
CERTAIN 2008 F-250 THROUGH F-550 SUPERDUTY VEHICLES
EQUIPPED WITH DRIVER SEAT LUMBAR
FRONT DRIVER SEAT BACK FRAME REPLACEMENT
INSTRUCTION SHEET
