F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
1.
Install the clamp on the driver seat back frame so that the clamp is located above the ridge on the inboard pivot bracket. Insure that the clamp nuts
point inward toward the lumbar support to avoid cushion damage. See Figure 7 for the correct location/orientation.
2.
Tighten the 2 clamp nuts to 15 Nm (133 lb-in) so that an equal amount of threads are exposed on both sides. See Figure 8.
3.
Install the protective caps on the exposed threads. See Figure 9.
