F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
5. Release the cushion trim cover J-clips.
6. From under the outboard side of the cushion frame, remove the pin-type retainers and remove the cushion trim cover.
7. Remove the cushion frame from the cushion foam pad.
-
If equipped with power seat track, feed the seat control switch wire harness through the opening in the cushion trim cover.
8. Remove the hog rings and cushion trim cover.
Seats with heat
9. Remove the cushion heater mat from the cushion foam pad.
-
On assembly, make sure the cushion heater mat is tucked in the trench.