F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
All seats
10. To install, reverse the removal procedure.
11. Install the front seat.
Driver seat
12. Prove out the SRS as follows:
Turn the ignition switch ON. Visually monitor the air bag warning indicator. The air bag warning indicator will light continuously for
approximately 6 seconds and then turn OFF. If an air bag SRS fault is present, the air bag warning indicator will:
-
fail to light.
-
remain lit continuously.
The air bag warning indicator might not light until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON
position. This is the time required for the RCM to complete the testing of the SRS. If the air bag warning indicator is inoperative and a SRS fault
exists, a chime will sound in a pattern of 5 sets of 5 beeps. If this occurs, the air bag warning indicator and any SRS fault discovered must be
diagnosed and repaired.
Clear all continuous DTCs from the RCM using a scan tool.
Driver seat with memory
13. Set the memory seat soft stops. For additional information, carry out Setting the Soft Stops in the Principles of Operation portion of Seats. See:
Testing and Inspection/Initial Inspection and Diagnostic Overview/Principles of Operation
