F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
4. Release the clips, slide forward and separate the cushion side shield insert.
5. Remove the seat control switch in the following sequence.
1
Remove the seat control switch knob.
2
Release the cushion side shield clips and separate the seat control switch.
3
Disconnect and remove the seat control switch.
6. To install, reverse the removal procedure.
7. Install the front seat.
Driver seat
8. Prove out the SRS as follows:
Turn the ignition switch ON. Visually monitor the air bag warning indicator. The air bag warning indicator will light continuously for
approximately 6 seconds and then turn OFF. If an air bag SRS fault is present, the air bag warning indicator will:
-
fail to light.
-
remain lit continuously.
The air bag warning indicator might not light until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON
position. This is the time required for the RCM to complete the testing of the SRS. If the air bag warning indicator is inoperative and a SRS fault
exists, a chime will sound in a pattern of 5 sets of 5 beeps. If this occurs, the air bag warning indicator and any SRS fault discovered must be
diagnosed and repaired.
Clear all continuous DTCs from the RCM using a scan tool.
