F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety
Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash
it with water.
All vehicles
1. With the engine off, press the brake pedal 7- to 8-times to discharge the booster.
2. Remove the air cleaner element. For additional information, refer to Fuel Delivery and Air Induction.
3. Remove the 2 bolts and position the degas bottle/lower air cleaner housing assembly aside.
^
To install, tighten bolts to 15 Nm (11 lb-ft).
4. Disconnect the brake fluid level switch electrical connector.
5. If equipped, disconnect the speed control deactivation switch and/or the trailer brake control transducer electrical connectors.
6. Disconnect the brake tubes from the master cylinder.
^
To install, tighten to 18 Nm (13 lb-ft).
Vehicles with vacuum boost
7. Remove the brake master cylinder nuts and the brake master cylinder.
^
To install, tighten to 27 Nm (22 lb-ft).
Vehicles with Hydro-Boost(R)
8. Disconnect the power steering line from the power steering line bracket.
9. Remove the power steering line bracket/master cylinder nut and position the bracket aside by first sliding it forward and then pivoting it to the
side.
^
To install, tighten to 30 Nm (22 lb-ft).
10. Remove the remaining brake master cylinder nut and the brake master cylinder.
^
To install, tighten to 30 Nm (22 lb-ft).
