F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
Parking Brake Cable: Procedures
Parking Brake Cable Tension Release
1. Remove the LH cowl side trim panel. For additional information, refer to Trim Panel.
2. CAUTION: Do not allow the cable to rub against any edges or other sharp objects. Damage to the cable may result.
With an assistant, release the parking brake cable tension by pulling straight back on the intermediate cable at the cable-to-cable union until the
parking brake control sector rotates to its stop and a 4 mm (0.15 inch) x 150 mm (5.9 inch) retainer pin can be inserted.
3. Disconnect the cable at the cable-to-cable union.
4. NOTE: Make sure the cable-to-cable union is connected to the front and rear cable before removing the brake control retaining pin, and the cable
tension is reloaded slowly.
To reload the tension on the parking brake cable, reverse the release procedure.
^
Check the parking brake for correct operation by applying and releasing the pedal a minimum of 3 times.
